GT6-14A CNC Rebar operation to seize the main points

       GT6-14A CNC Rebar working environment is very dangerous, so steel straightening machine operation must be strict, safe operation.
First, according to the bar diameter straight tone, choose the appropriate straightening block, entrainment wheel slots and drive speed. Straightening block aperture is larger than the bar diameter should be 2 ~ 5mm, the same width and the traction wheel straightening bar diameter.
Second, straightening adjustment block. Within the general tone straight five straight blocks, the first of two straight blocks 1,5 shall be placed in the line will be in the middle of the three may be offset from the centerline. First make steel offset about 3mm offset through test tone, such as reinforced still slow corners, gradually increase the offset until straightening up.
Third, cut three or four bars need to stop after checking the length is appropriate, subject to bias, adjustable limit switches or length plate, until the appropriate date.
Fourth, in the front portion of the guide tube should be installed about 1 meter steel one.Gt6-14a CNC Rebar should be transferred through the first pipe, and then penetrate the guide tube and transfer straight to prevent pop wounding nearly every dish reinforced straight when finished.
Fifth, the straightening block is not fixed, the shield is not covered before, can not penetrate reinforced in order to prevent the switch on the machine, straight block flying wounding.
Sixth, the machine allowed to pile up objects to prevent mechanical vibration objects have fallen into the body. Reinforced load pressure roller, hand drum should maintain a certain distance, the drum machine operation shall not be adjusted, non-gloved hands.
Seven, Gt6-14a CNC Rebar is not adjusted until the end, people have to avoid, prevent swinging wounding. Shorter than 2m or larger in diameter than steel straightening 9mm should low speed processing.