1.GT6-14A CNC Rebar must be operated by hand. The operator must go through specialized security knowledge assessment, certificates after passing the examination. Mechanical installation should be solid stable, horizontal position. Fixed machinery should be a reliable basis; when moving mechanical work wedged tight walking round.
2. Mechanical prohibited ill job, find fault must be immediately shut down, turn off the power, by a professional mechanical maintenance man responsible for maintenance must assign someone to monitor mechanical maintenance. You must set the anti-smashing, rain hangar beside the machine should have piled raw materials, semi venues.
3. Longer bars during processing, should be someone helping, and obey the command of the operator, shall be arbitrarily sliding.
4. Feeder, the trough should be installed straight, and should be aligned with the guide tube, and the lower knife adjusting centerline straight holes.
5. After applying hand turn the flywheel to check the drive mechanism and the working device, adjust the gap, tightening bolts, confirm normal, start air operation, and no abnormal noise should check the bearings, gears meshing well, after operating normally before the job.
6. Gt6-14a CNC Rebar Should straighten rebar diameter, choose the appropriate straightening blocks and transmission speed. Aperture straightening block should Reinforced big 2 ~ 5mm, transmission speed should be chosen depending on the diameter, larger diameter should use slow, after debugging qualified before feeding.
7. In straightening block is not fixed, the front shield cover shall not feed. The job is strictly prohibited open the protective cover and adjust the gap ministries.
8. When Gt6-14a CNC Rebar is fed, hand and drag wheel should maintain a certain distance, can not close.
9. Before feeding, should not straight steel tip resection. Guide tube should be installed before a 1m long steel pipe, steel pipe and then should be fed straight through the front of the guide hole.
没有评论:
发表评论