Master CNC steel models straightening techniques are very important

    Some novices in the use of CNC steel models for some time, will feel out of tune bending of reinforcement is not high. This is because some bending hoop wheel may appear loose, there may be considered misuse, leading to horizontal adjustment wheel, the rotational position of the intermediate bending hoop wheel deviation. If it is about bias, appropriate adjustments to some of the hoop bending machine cutting machine front end of the horizontal adjustment wheel so that the gap several intermediate wheels on the same line, after the adjustment, and then observed.    CNC steel models cut occurs constantly reinforced the case, you should check the following areas: the solenoid valve, exchanges and contacts, proximity switches and relays. One by one to check these parts need to be cleaned to clean up, if there is damage to be replaced, one by one investigation after another start running, it is possible to solve the bending hoop machine continue to cut steel case.   If the Big Bend, reinforced on the floor, obviously feeling can be bent, which it needs to adjust the rotation of the intermediate portion. Open the protective cover, adjust bending hoop wheel adjustment nut wrench reduce the gap between CNC steel models round. After adjusting the run, we can solve this problem.   Bending hoop machine is actually a simple and easy to operate, if you do routine maintenance is in place, but also in the work of past experience, it would be handy to use, it will be your assistant.